top of page
IMG_2668.HEIC

Specialty/Small run Saws

In addition to the F Series saws I will be doing small runs of passion project saws and perhaps a few other tools. I will do my best to list the specs of these saws. But until they are done nothing is set in stone. I will accept pre orders on all of the saws listed here, to put your name on said list. Please reach out via email. There are no set in stone time lines for these saws in roughly chronological order below. 

IMG_4387 - Copy.HEIC

Curly Cherry Panel Saws $325CAD-Sold out

These will be my first prototype panel saws. These are aimed at an affordable mid range saw. Meant to fall into the canyon left between the PAX and Bad Axe offerings.

​

They will be hammer set and hammer tensioned but not taper ground or breasted. 

.042 steel

8ppi crosscut

Curly Maple Half Back 
$375CAD-Sold out

This is a halfback prototype.

A wonderful saw to have on the bench, akin to a jack plane of saws. Hammer tensioned, hammer set. 
19" length

6" brass

8PPI Crosscut

.032 Steel

1 available

IMG_4467.HEIC
IMG_4331 - Copy.HEIC

Walnut&Damascus Triple Cove Carcass saw $700CAD

This is the first venture into triple cove backsaws for me. A classic early Philadelphia style. 
This will feature a Damascus back.

Steel Steeple/conical bolts

An etch reserved for specialty saws

12PPI filed hybrid.

A checkered handle/tote

A detailed toe to compliment the triple cove handle. 

6 Available.

Curly Cherry Triple Cove Carcass saw $400

This saw is meant to mimic the bells and whistles of the Damascus saws but not the cost of steel. So a fluted brass back replaces the Damascus and brass steeple/conical bolts. 

​

An etch reserved for specialty saws

12PPI filed hybrid.

A checkered handle/tote

A detailed toe to compliment the triple cove handle. 

12 Available.

IMG_4331 - Copy.HEIC
bottom of page